Floor Console FAQs

Yes, absolutely. Our products are supplied with fitting instructions (most are also available on our Fitting Instructions page), and support via email or over the phone.

es, you can. Search “Replacement Lid” on our online store to view and purchase the available options. We require clear photos of your existing console so our team can match the vinyl colour and style as closely as possible. Whether your console is new or decades old, we have you covered. Our consoles have been used and loved for over 50 years, and we understand that some may need a refresh along the way. Don’t need a complete replacement lid? We also offer Lid Covers, designed to protect your existing lid from everyday wear and tear.

If your vehicle came from factory with two bucket seats and a factory console/plastic tray, our console mounts using the existing mounting points.

If your vehicle had three seats in the front row from factory (driver’s bucket seat + passenger’s bench seat), you will need to drill new mounting points in the floor. We supply all required hardware.

Yes. Email us with your requirements, including accessory model numbers, and we’ll confirm feasibility.

Yes, the front accessories facia is angled for visibility and ease of operation. Compatibility varies depending on UHF model due to space and airbag/sensor positioning. We are an authorised GME dealer and can supply/install compatible units. Contact us for specific advice.

For bucket + bench factory setups: we require photos to check for bracket or obstruction clearance.

For factory twin-bucket setups: designed to fit most aftermarket seats. Console is 190mm wide — check clearance before ordering.

88mm internal diameter, 75mm depth, with a smaller tier in the base for cans.

Yes, with our jumbo cup holder disks, which level out the tiered base to suit sizes in between. Alternatively you can use our Big Caddy Adapter.

190mm wide × 125mm long × 55mm deep.

Narva Australia Heavy-Duty Twin Accessory/Dual USB Sockets.

No — we use ABS plastic to prevent rattles from coins, cans, or mugs.

Yes, available in any colour of your choice. We can match most materials from Australian suppliers.

No — colour range limitations and the inflexible nature of leather make it unsuitable for our complex shapes.

No, the decorative gear boot in our product requires the factory rubber boot to stay in place for sealing and noise prevention.

No, we only supply our fully finished, upholstered products.

No — a front recess allows the glove box to open without contact.

Exterior grade, marine-bonded plywood, finished with soft padded vinyl upholstery to match your interior.

Original Full Length Console — straight design that stops before the 4WD selector. One accessory position on the driver’s side. Same high-quality vinyl and trimming options as Premium.

Premium Full Length Console — extended design that wraps neatly around the 4WD selector. Two additional accessory positions on the driver’s side (three in total). Same high-quality vinyl and trimming options as Original.

Fit & Finish: Both models are precision-built for your vehicle, using the same upholstery, colour matching, and padded armrest lid. The choice comes down to whether you want the extra accessory space and the wrap-around style of the Premium.

Dimensions

76 Series Wagon (2009–current) & 79 Series Dual Cab (all models)
Height: 494mm (incl. armrest/padded lid)
Width between the seats: 190mm

79 Series Single Cab (2016+)
Height: 494mm (incl. armrest/padded lid)
Width between the seats: 190mm

79 Series Single Cab (2009–2016)
Height: 380mm (incl. armrest/padded lid)
Width between the seats: 190mm

78 Series TroopCarrier (2009–current)
Height: 380mm (incl. armrest/padded lid)
Width between the seats: 190mm